I have an bare-bones app you can run on Android to do this here, but you'll need a copy of Android Studio to build and run it. If the above two suggestions don't help, I would use an independent tool such as an Android phone to actually count the number of BLE packets detected. RadBeacon is certified and licensed by the FCC, CE, Bluetooth and more. ![]() However, we recommend using our official RadBeacon USB Power Supply. You can use any USB AC adaptor, car adaptor, or computer with a spare USB port. While it is certainly possible that you have one device with a hardware issue (low battery, broken antenna, etc. Bring your transmitter and receiver closer together. RadBeacon USB is powered from any standard USB port. I have a RadBeacon Dot on my desk, and I count 8-10 packets per second received by an Android device next to it when it is configured to advertise at 10Hz.Having the weakest power output configured is the most likely cause of your issue. With the RadBeacon app you can scan for nearby configurable Radius Networks beacons. Increase your transmitter power level from -18 dBm to 3 dBm. The RadBeacon app is the configuration utility for RadBeacon proximity beacons from Radius Networks that support Apples iBeacon proximity services as well as other emerging proximity services. The RadBeacon E4 supports the 4 most popular beacon protocols iBeacon, AltBeacon, Eddystone UID, and Eddystone URL.) to this page, please send email to: arn0 (at) (replace (at) by ) Go to: Manual & Diagram, Blank Setup Sheet, Base Setup Sheet, Tips & Tricks. If you want to add information (setup, tips. Since your detection rate is much lower, you may want to try a number of things: - English - Deutch - Franais - Espaol - Italiano - Slovensky. Under good conditions (close range, high transmitter power), I typically see 80-90% of packets get detected by Android and iOS devices which allow you to easily count individual BLE packets. Antennas on both transmitter and receiver.The actual percentage received depends on a number of factors including: ![]() Not 100% of advertising packets send out by a Bluetooth LE device will be detected by receiving devices.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |